Оптимизация температурного профиля заготовки ПЭТ

Sun, 07 Jun 2026 05:15:20 +0800

Out on the line, a preform heat profile that’s drifting will quietly eat your yield. Stretch ratios slip, bottles haze up, and the whole line slows down while you chase temperature balance. The answer isn’t more power. It’s repeatable, machine-matched infrared heat. What actually matters under the hood We spec short-wave infrared emitters with quartz tubes and halogen filaments, chosen for fast response and stable output across the heating tunnel. Each lamp is defined by wattage, voltage, length, and base—usually R7s—so the energy density lines up with preform wall thickness and cycle time. Reflector geometry and spectral output get tuned to keep the skin from scorching while the core hits the right temperature for stretch blow molding. Why this approach fits your floor It’s built to play with the blow molders you already run. The emitters drop into Sidel Matrix, Krones Contiform, and Husky HyPET platforms, fitting existing lamp holders and wiring without reworking the heating section. When the heat profile matches the machine, you get a tighter distribution, fewer pinholes, and more consistent bottle weight. Energy use drops because the tunnel stops overshooting, and lamp life stretches out—fewer spares to stock and less downtime. The install details that make the difference Installation is straightforward, but alignment is not optional. Check preform rotation, keep reflectors clean, and verify cooling airflow. If any of that is off, you’ll still get hot spots and uneven heating—even with the right lamp. And if you move to heavier preforms or a different resin grade, the heat profile will need re-tuning. Run a small validation batch, lock in the settings, then scale up.

Преформа on The Infrared Heating King

Оптимизация температурного профиля заготовки ПЭТ